Cut and Seal in a Single Pass
Cutting textiles and leather is a CO2 job that cuts and seals the edge in the same pass. On fabric, the heat melts the edge just enough to stop fraying; on leather, it leaves a clean sealed line with no skiving. There are no dies to make and no blades to sharpen, so a new pattern is a file change rather than a tooling job. This page is a short guide to how the process works and what drives the choice.
What Matters Here
Power is modest for this work, because the material is thin — so the real wins are working area, throughput, and options like a conveyor or vision registration for cutting printed material to its artwork. The value is short runs and frequent design changes without die costs.
Typical Uses
Apparel and accessories makers, upholstery and automotive-interior shops, and promotional-goods producers are the typical users. The appeal is fast pattern changes and no die costs, which suits high-mix, short-run production.
Where Topstar Fits
Textile and leather cutting uses a CO2 source, a different process route from Topstar’s own line, which is fiber for metal — sheet metal, precision parts, and tube and profile. If your work is metal, those pages are the right starting point. To mark leather or fabric rather than cut it, a CO2 laser marker handles that.
